EtherNet/IP to SICK Barcode Scanners


This product complements our hugely successful DeviceNet to SICK Barcode Scanner Interface.

Communications with all types of SICK CLV Scanners on the plant floor is now a standard requirement. One of the major hurdles when connecting multiple devices back to a common processor is the number of communication ports that are required and the complexity of writing the protocol driver.

This product will enable you to quickly and easily integrate SICK’s range of barcode scanners into your EtherNet/IP installation. The simplicity of the mapping of data directly into the PLC data table will make connection of barcode scanners so much easier and faster. This allows you to concentrate on your factory process.

An extensive range of parameters allows you to configure the module to suit your exact barcode tracking requirements.


  • 10/100Mbit RJ45 EtherNet/IP interface
  • High density D15 connector for direct connection to your SICK Barcode Scanner
  • Supports a wide range of SICK Barcode Scanners
  • Smart Barcode Scanner configuration – eliminates the requirement to pre-configure your barcode scanner
  • 1 x 24V digital input (can be configured as scanner trigger)
  • 1 x 24V digital output
  • Rugged DIN rail mounted aluminium enclosure
  • Simple easy to use interface
  • Web server diagnostics and configuration
  • Cost effective
  • Isolated Module Power and I/O Power Connections
  • Multiple IP Address configuration options


Ordering Information - TCS Part Number007-0058-000
DescriptionEthernet IP to SICK Barcode Scanner Interface
NetworkEthernet/IP 10/100MBit full/half duplex
EthernetIP Ethernet/IP level 2 I/O Server CIP
Network IsolationGalvanically Isolated
IP address ConfigurationDHCP, web configuration system, PC utility
Network Connector RJ45 Ethernet
Serial CommunicationsRS422
Serial Baud Rate 9600, 8, 1, N
Serial ConnectorHigh Density D15 female for direct connection to SICK Barcode Scanner
IndicatorsNetwork Status
Module Status
Serial Tx
Serial Rx
Inputx 24V DC input
Output1 x 24V DC Output (1A)
I/O connector6 pin push fit Phoenix Connector
I/O Isolatio Optically Isolated - 2.5KVrms min
I/O Connector6 pin push fit Phoenix Connector*
Supply Voltage11 - 27V DC
Supply Power Connector6 pin push fit Phoenix Connector*
EnclosureAnodised Aluminium
Dimensions30mm(W) x 82mm(H) x 115mm(D)
MountingDin rail mounting to EN50022
Relative Humidity5% to 95%
Operating Temperature-25°C to 70°C (-18°F to 158°F)
Smart Barcode Scanner configurationIncluded
Barcode Maximum on timeSelectable (1ms-10s)
Barcode Minimum on timeSelectable (1ms-10s)
Trigger SourceSelectable (continuous, network trigger or sensor trigger)
Trigger Debounce TimeSelectable (0-10s)
Barcode Scanner ConfigurationSelectable (none, NVROM, ROM, SICK)
Trigger StateSelectable (active ON or active OFF)
I/O Fault ActionSelectable (OFF, Hold last state)
*Shared 6 way push fit Phoenix Connector for Module Power, I/O Power and I/O